Pass4sure---help you pass cisco exams

TestInside 642-355

Cisco Storage Networking Solutions Design Specialist (CSSDS) : 642-355 Exam
Exam Number/Code: 642-355
Exam Name: Cisco Storage Networking Solutions Design Specialist (CSSDS)
Questions and Answers: 60 Q&As
Price: $79.00
Update Time: 2008-5-10

“Cisco Storage Networking Solutions Design Specialist (CSSDS)”, also known as 642-355 exam, is a Cisco certification.
Preparing for the 642-355 exam? Searching 642-355 Test Questions, 642-355 Practice Exam, 642-355 Dumps?

Free 642-355 Demo Download
TestInside offers free demo for 642-355 exam ( Cisco Storage Networking Solutions Design Specialist (CSSDS)). You can check out the interface, question quality and usability of our practice exams before you decide to buy it. We are the only one site can offer demo for almost all products.

1. Which technology should be used to provide transparent low latency FC transport across a metropolitan area?

A. DWDM B. FCIP
C. iSCSI D. iFCP Answer: A

2. Which statement is true concerning the Cisco MDS switch when operating in native interop mode?

A. The MDS switch can interoperate with Non-MDS switches that are certified by SNIA.

B. The MDS switch can interoperate with Non-MDS switches that support “MDS Native” mode.

C. The MDS switch can interoperate with Non-MDS switches that properly adhere to Fibre Channel switch standards.
D. The MDS switch cannot interoperate with Non-MDS switches. Answer: C

3. A customer has a need to synchronously replicate data from the primary data center to a standby data center that

is 30 kilometers away. The customer owns the fiber between the two data centers and uses the link for Gigabit

Ethernet connectivity today. The Gigabit Ethernet connection is heavily utilized and generally remains at

90-percent utilization. The customer expects that the replication traffic will require approximately 30 MBps, and

is looking for a low-cost solution.

Which replication solution would you recommend? A. FCIP
B. CWDM C. DWDM D. iSCSI Answer: B

4. A customer would like to add Cisco MDS switches to an existing Brocade environment with minimal disruption. The Brocade switches are using PID-0 mode. Which two features will enable the creation of a Cisco-Brocade heterogeneous fabric without restricting the feature set of either switch? (Choose two.)
A. interop mode 1

B. interop mode 2

C. interop mode 3

D. IVR

E. PortChannels F. CWDM Answer: BD

5. Your customer has a number of data storage requirements:

servers are not responsible for volume management or data migration storage is provisioned in real time
legacy and heterogeneous storage assets can be consolidated and fully utilized data can be protected using simplified snapshot and replication techniques
data can be assigned to different classes easily Which solution would meet these requirements? A. VSANs
B. Wide-Area Application Services (WAAS) C. fabric-based virtualization
D. LUN zoning

E. host-based virtualization

Answer: C

6. Select three advantages of using fabric-based storage virtualization instead of host-based virtualization.

(Choose three.)

A. offers a single point of management

B. supports heterogeneous storage

C. does not require a host agent

D. insulates the hosts from storage changes

E. provides mirroring

Answer: ACD

7. Which are two characteristics of the Cisco MDS Series fan modules? (Choose two.)

A. Supervisor modules shut down the fan modules when the air temperature is below a preset threshold.

B. If the Fan Status LED turns red, a fan has failed and the module must be replaced.

C. Fan modules monitor air temperature and shut down if the temperature exceeds a preset threshold.

D. Fan modules do not require the switch to be powered off in order to be replaced. Answer: BD

8. Your customer is using an IPS-8 module in its data center to provide FCIP connectivity to 20 remote sites. It has encountered connectivity problems at four of the remote sites. After investigating, the customer’s network administrator found that the IPS-8 is sending 2300-byte packets, but the receiving switches at the four remote sites
do not support jumbo frames. What should you do?
A. Disable packet shaping on the IPS-8

B. Reduce the minimum retransmit timeout

C. Disable jumbo frames on the IPS-8

D. Enable Path MTU discovery

Answer: D

9. Your SAN environment requires redundant fabrics with redundant connectivity for 40 database hosts at 2 Gbps

of throughput per host. Which two of these configurations are possible? (Choose two.) A. two 48-port line cards
B. four 48-port line cards C. four 32-port line cards D. six 16-port line cards
E. two 32-port line cards and two 16-port line cards

Answer: BD

10. Your customer wants to implement a SAN with redundant fabrics supporting 600 device ports. Which two

Cisco MDS 9000 Family configurations will meet the customer’s needs? (Choose two.) A. two MDS 9509 switches with redundant Supervisor-1 modules
B. two MDS 9509 switches with redundant Supervisor-2 modules

C. two MDS 9513 switches with redundant Supervisor-1 modules

D. two MDS 9513 switches with redundant Supervisor-2 modules

Answer: BD

Free download:pass4sure 642-355
Free download:testking 642-355

TestKing - TestKing.com Help you pass Cisco exams

Pass4sure -Pass4sure.com The Worldwide Renowned Cisco Certification Material Provider .

Free Testking

Random Posts

Free pass4sure cisco

Comments (3)

[...] Sales Expert Testinside Cisco 646-011 Storage Networking Cisco Storage Sales Specialist (CSSS) Testinside Cisco 642-355 Cisco Storage Networking Solutions Design Specialist (CSSDS) Testinside Cisco 642-356 Cisco Storage [...]

[...] Sales Expert Testinside Cisco 646-011 Storage Networking Cisco Storage Sales Specialist (CSSS) Testinside Cisco 642-355 Cisco Storage Networking Solutions Design Specialist (CSSDS) Testinside Cisco 642-356 Cisco Storage [...]

hpexams.blogr.com - stories - 8197739October 6th, 2008 at 6:44 pm

[...] [...]

Leave a comment

Your comment