Download Free Pass4sure Cisco 642-964 Exam Dumps | Latest Cisco Certification Exams

Pass4sure Cisco 642-964 Exam

Cisco Data Center Networking Infrastructure Solutions Support : 642-964 Exam

Exam Number/Code: 642-964
Exam Name: Cisco Data Center Networking Infrastructure Solutions Support

Exam : Cisco 642964

Title :

Cisco Data Center Networking

Infrastructure Solutions Support

Update : Demo

1.What will be upgraded as a result of this command? upgrade
ftp://ftpuser@10.1.2.3//upgrade/IPSK9r1.1a5.11.pkg
A.recovery partition
B.application partition
C.both application and recovery partitions immediately
D.both application and recovery partitions at the next scheduled automatic IDSM update
Correct:A
2.On a Cisco Catalyst 6500 Series Switch, how many physical links can be aggregated into an
EtherChannel group?
A.4
B.8
C.16
D.32
Correct:B
3.How would you configure a NAM to monitor and report the most heavily viewed sections of a website?
A.Create a separate domain name or virtual server IP address for each section of the site. Add each domain name or IP address to the NAM application protocol directory.
B.Enable regularexpression pattern matching. Define application protocol filters based on regular expressions that match the desired URLs.
C.Enable URL monitoring. Define each desired URL as an application in the protocol directory.
D.Use SPAN or VACLs to capture upperlayer protocol data from the web servers. Use a thirdparty application to parse the stored capture files.
Correct:C
4.How can you configure the NAM to view a list of all switches that are sending NDE packets?
A.Enter the command sh datasource nde.
B.Configure Cisco Discovery Protocol to detect all switches on the network. C.Launch NetFlow Listening Mode from the Cisco Traffic Analyzer application.
D.The NAM will automatically detect NDE broadcasts and add each switch to the NetFlow device table.
Correct:C
5.Refer to the exhibit. Which FWSM command allows routing of TCP traffic from the Internet to network 10.0.3.0/24?

A.accesslist inside permit tcp 192.168.1.0 255.255.255.0 10.0.3.0 255.255.255.0
B.route inside 10.0.3.0 255.255.255.0 10.0.1.3
C.route outside 10.0.3.0 255.255.255.0 10.0.1.3
D.route inside 0 0 10.0.1.3
Correct:B
6.Which command must be issued to activate the FWSM firewall context?
A.allocatevlan B.configurl C.limitresource D.mapinterface Correct:B
7.The IDSM managementinterface IP address can be configured from which prompt?
A.IDSM(config)# B.IDSM(confighosnet)# C.IDSM(configmgmt)# D.IDSM(configif)# Correct:B
8.Refer to the exhibit. Which command would you use on the FWSM to provide a default route from Servers 1 and 2 to the Internet?

A.route inside 0 0 192.168.100.1
B.route inside 10.1.0.0 255.255.0.0 192.168.1.1
C.route outside 0 0 192.168.100.1
D.route outside 10.1.0.0 255.255.0.0 192.168.1.1
Correct:C
9.Which statement is correct regarding Layer 3 EtherChannels?
A.They are STPaware.
B.They cannot be automatically negotiated.
C.Multiple EtherChannels are used between a pair of switches. D.Multiple EtherChannels between two switches create an STP loop. Correct:C
10.What is the effect of executing the command intrusiondetection module 5 managementport accessvlan 10 on an IDSM?
A.allows the IDSM to be managed by devices in VLAN 10
B.configures the IDSM to monitor traffic from VLAN 10 in inline mode
C.allows the IDSM to perform blocking actions on devices in VLAN 10
D.configures the IDSM to monitor traffic from VLAN 10 in promiscuous mode
Correct:A
11.Which three statements are requirements for configuring a web browser to work with the NAM Cisco Traffic Analyzer? (Choose three.)
A.Enable Java and JavaScript.
B.Set the browser cache to at least 500 MB. C.Configure the browser to accept all cookies. D.Install the Cisco Traffic Analyzer application.
E.Set the browser cache to clear itself automatically when the user exits the browser. F.Configure the browser to check for newer versions of pages every time it loads a page. Correct:A C F

12.Which step will configure high availability on two IDSMs in inline mode?
A.Configure an EtherChannel between the two IDSMs. B.Enable hardware bypass on the primary IDSM. C.Enable software bypass on the backup IDSM. D.Install the IDSMs in separate chassis.
Correct:C
13.Your customer uses these fileoriented network applications: FTP Webbased file repositories Windows and Linux file sharing How can you use the NAM to create a report showing total network traffic for these applications?
A.Define a VACL that forwards traffic for all of the applications.
B.Define an application group that contains all of the interfaces for the application servers. C.This cannot be accomplished because the NAM cannot monitor upperlayer protocol data.
D.Add each application to the Cisco Traffic Analyzer protocol directory and create an application group with all of the applications.
Correct:D
14.Refer to the exhibit. Given this network design, what can you use to configure the IDSM to capture traffic?

A.SPAN
B.VACLs
C.SPAN or VACLs
D.neither SPAN nor VACLs
Correct:D
15.Which configuration is needed for the NAM to display perprotocol statistics for MPLStagged packets?
A.Configure SPAN for WAN data collection.
B.No configuration is needed? this option is operational on powerup.
C.The NAM cannot provide perprotocol statistics for MPLStagged packets.
D.Configure the NAM to the “Parse MPLS tagged packet” option in Cisco Traffic Analyzer.
Correct:D
16.When is the currentconfig file updated on the IDSM?
A.after you exit configuration mode
B.after each configuration command is entered
C.when you execute the copy run start command

D.when you execute the save currentconfig command
Correct:A
17.In a Cisco Catalyst 6500 Series Switch, in which slot or slots should you install the NAM?
A.slots 1 to 4
B.slot 5 or 6
C.any slot except a supervisor module slot
D.the slots that are closest to the supervisor modules
Correct:C
18.How can you configure the NAM to create a report that shows the percentage of traffic that is assigned to each DSCP service level?
A.The NAM can only capture DSCP data for voice traffic.
B.Use NetFlow on the NAM to capture DSCPlevel protocol statistics.
C.Enable DiffServ monitoring using a user profile containing DiffServ aggregation groups.
D.Use a thirdparty application to parse upperlayer protocol data captured from web servers.
Correct:C
19.A customer has installed an FWSM in the data center. Which feature must be configured to enable FTP to work?
A.dynamic NAT B.dynamic PAT C.access lists D.transparent mode
E.deep packet inspection
Correct:E
20.What can you do to obtain faster RPR+ failover?
A.Use RPR instead of RPR+.
B.Disable core dump on both supervisors. C.Decrease the supervisor synchronization interval.
D.Minimize the number of entries in the Layer 3 routing tables.
Correct:B
21.Which IDSM capture method has the ability to impact the performance of VoIP applications?
A.inline B.promiscuous C.SPAN D.VACLs Correct:A
22.How many IDSMs can monitor the same VLAN?
A.2
B.4
C.8
D.32
Correct:C
23.What will be the result of this command? bgp gracefulrestart
A.NSF is enabled for BGP.

B.SSO is enabled for BGP.
C.RPR is enabled for BGP. D.RPR+ is enabled for BGP. Correct:A
24.A customer network is configured as follows: NetFlow is on for all core switch interfaces. The NAM receives NDE packets from each switch. Reports show aggregate data for all interfaces. How would you view data for specific interfaces on a given switch?
A.Enable NetFlow only on the interfaces that you want to view. B.Create ACLs on the NAM data ports to filter the NDE traffic.
C.Create a custom NDE data source in Cisco Traffic Analyzer and specify the interfaces that you want to view.
D.Limit the NDE data capture by specifying the VLANs that apply to the interfaces that you want to view.
Correct:C
25.Refer to the exhibit. IDSM blocking is indicated by the dotted arrows. What is the correct method for implementing this blocking configuration?

A.This configuration cannot be implemented.
B.Create a blocking group for each router, and add the appropriate IDSMs to the blocking group.
C.Using IDM, add the IP addresses of the appropriate routers to the Blocking Devices table of each IDSM. D.Configure the IDSM that is nearest to the Internet as a master blocking sensor, and configure the other IDSMs as block forwarding sensors.
Correct:D
26.Refer to the exhibit. HSRP interface tracking is disabled on Switch A interface WAN0. Link 1
fails. Which statement is correct?

A.Traffic that is routed through HSRP Group X will not fail over to Switch B when Link 1 fails.
B.Traffic that is routed through HSRP Group Y will not fail over to Switch D when Link 1 fails.

C.Traffic that is routed through HSRP Group Y will not fail back to Switch C when Link 1 comes back
online.
D.Traffic that is routed through HSRP Group X will not fail back to Switch A when Link 1 comes back online.
Correct:A
27.Which signature action can be configured only on an IDSM sensor in IPS mode?
A.log packets containing the attacker and victim address pair
B.modify data in the packet
C.send a request to block a connection
D.terminate the TCP flow
Correct:B
28.A switch is running RSTP and is connected to a switch running 802.1D. What happens when a spanningtree reconvergence is triggered?
A.The switches cannot converge. B.Both switches revert to STP mode.
C.The switch running RSTP reverts to 802.1D mode. D.The switch running 802.1D reverts to RSTP mode. Correct:C
29.What is required when configuring NTP on the IDSM?
A.Configure an MD5 key.
B.Add a service account for the NTP service.
C.Configure the IDSM host access list to allow access to the NTP server.
D.Associate the VLAN containing the NTP server with the IDSM management port.
Correct:A
30.How can a customer with multiple FWSM contexts limit the number of connections that are permitted in each context?
A.Map the context to a class, and apply resource limits to the class. B.Map the context to a VLAN, and apply resource limits to the VLAN. C.Map the context to a class, and apply resource limits to the context.
D.You cannot limit the number of connections that are permitted in a context.
Correct:A

“Cisco Data Center Networking Infrastructure Solutions Support”, also known as 642-964 exam, is a Cisco certification.
Preparing for the 642-964 exam? Searching 642-964 Test Questions, 642-964 Practice Exam, 642-964 Dumps?

With the complete collection of questions and answers, Pass4sure has assembled to take you through 60 Q&As to your 642-964 Exam preparation. In the 642-964 exam resources, you will cover every field and category in Others helping to ready you for your successful Cisco Certification.
Questions and Answers : 60 Q&As
Updated: April 11th , 2008
Market Price: $129.99
Member Price: $99.99

Free Down:Pass4sure Cisco 642-964 v2.93
Free down:Testking 642-964

password:www.dynagen.cn