Pass4sure CCIE Storage Networking 350-040 Exam
CCIE Storage Networking : 350-040 Exam
Exam Number/Code: 350-040
Exam Name: CCIE Storage Networking
VUE Code: 350-040
TestInside 350-040
Cisco 350-040
Cisco® CCIE Storage Networking
Q&A DEMO
TestInside,help you pass any IT exam!
TestInside 350-040
1.What is TCP fast recovery?
A: It is an algorithm that uses fast retransmit when a missing segment is detected.
B: It is an algorithm that initiates slow start instead of congestion avoidance after fast retransmit sends what appears to be the missing segment.
C: It is an algorithm that starts congestion avoidance instead of slow start after fast retransmit sends what appears to be the missing segment.
D: It is an algorithm that after a new connection is established with a host on another network, initializes the congestion window to one segment and each time an ACK is received, increases the congestion window by one segment
Correct Answers: C
2.What statement is TRUE?
A: A SPAN session can capture traffic originating from or destined for an end device, while an MDS fcanalyzer can only capture traffic originating from, or destined for, the supervisor.
B: An MDS fcanalyzer can capture traffic originating from, or destined for, an end device, while a SPAN can only capture traffic originating from, or destined for, the supervisor.
C: SPAN cannot capture traffic destined for the supervisor; the MDS fcanalyzer must be used instead.
D: SPAN can be used to determine why a port cannot autonegotiate to 2Gbps instead of 1Gbps.
E: Only when an SD port detects that it is attached to a Cisco PAA (Port Analyzer Adapter) will it use Buffer to Buffer Flow
Control.
Correct Answers: A
3.A Brocade 12000 in its native corePID mode (1) is connected to VSAN 1009 on an MDS. What is the correct output of the “show vsan 1009″ command?
A: vsan 1009 information name:VSAN1009 state:active interoperability mode:default loadbalancing:src-id/dst-id/oxid operational state:up
B: vsan 1009 information name:VSAN1009 state:active interoperability mode:1 loadbalancing:src-id/dst-id/oxid operational state:up
C: vsan 1009 information name:VSAN1009 state:active interoperability mode:2 loadbalancing:src-id/dst-id/oxid operational state:up
D: vsan 1009 information name:VSAN1009 state:active interoperability mode:3 loadbalancing:src-id/dst-id/oxid operational state:up
E: vsan 1009 information name:VSAN1009 state:active interoperability mode:Brocade Native loadbalancing:src-id/dst-id/oxid operational state:up
Correct Answers: D
4.AAA(TACACS+, Radius) protocols can not be used to authenticate and/or authorize what on MDS? A: Telnet and Console access
B: SSH C: RBAC
D: dhchap for fabric security
E: CUP
Correct Answers: E
5.A customer needs SAN extension for a distance of 200 kilometers for a mission-critical application. Assuming the
customer owns the dark fibers between the 2 locations, what technology can provide the best reliability, performance, and scalability?
A: Single mode dark fiber with long wave GBIC/SFP
B: FCIP over dedicated leased line
C: DWDM with BLSR (bidirectional line switched ring) D: CWDM with failover protection by application Correct Answers: C
6.”SCSI LUN discovery” is triggered automatically when: A:An IPS module is installed in an MDS switch
B:A CSM module is installed in an MDS switch
C:An ASM module is installed in an MDS switch
D:A 16 port FC Line card installed in an MDS switch
E:The switch has dual supervisors
Correct Answers: A, B, C
7.When a port channel that is trunking a given VSAN is quiesced, frames are lost. What can be inferred about this
VSAN?
A: The VSAN is a FICON VSAN.
B: In-Order Delivery is enabled for the VSAN. C: QoS is enabled for the VSAN.
D: Exchange-based load balancing is configured for the VSAN. E: Flow-based load balancing is configured for the VSAN. Correct Answers: B
8.ip access-list acl1 permit ip any any ip access-list acl1 deny tcp 10.1.1.1 0.0.0.0 eq port telnet any ip access-list acl1 permit tcp 10.0.0.0 0.0.255.255 eq port telnet any ip access-list acl1 deny icmp any 10.1.1.1 ip access-list acl1 permit icmp 10.0.0.0 0.0.255.255 any ip access-list acl1 deny udp any any interface mgmt0 ip access-group acl1 ip address
10.1.1.1 255.255.255.0 Given the above IP access list configured on MDS, Which are true? A:MDS can not telnet to host 10.0.1.1
B:Host 10.0.1.1 can telnet to MDS 10.1.1.1
C:Host 10.0.1.1 can not ping with ICMP to MDS mgmt0
D:MDS mgmt0 can not access tftp server using UDP E:MDS mgmt 0 can ping host 10.0.1.1
Correct Answers: B, E
9.What is a valid file type and name created when using the Performance Manger wizard to create a collections file for a switch named MDS2 ?
A: MDS2_PM.xls
B: MDS2_PM.doc
C: C9216-2_06242004.xls
D: MDS2_PM.html
E: MDS2.xml
Correct Answers: E
10.When a port channel that is trunking a given VSAN is quiesced, frames are lost. What can be inferred about this
VSAN?
A: The VSAN is a FICON VSAN.
B: In-Order Delivery is enabled for the VSAN.
C: QoS is enabled for the VSAN.
D: Exchange-based load balancing is configured for the VSAN. E: Flow-based load balancing is configured for the VSAN. Correct Answers: B
“CCIE Storage Networking”, also known as 350-040 exam, is a Cisco certification.
Preparing for the 350-040 exam? Searching 350-040 Test Questions, 350-040 Practice Exam, 350-040 Dumps?
Questions and Answers : 397 Q&As
Updated: Sep 5th , 2008
Market Price: $159.99
Member Price: $99.99
Free download：pass4sure CCIE Storage Networking 350-040
Free download：testking CCIE Storage Networking 350-040
TestKing - TestKing.com Help you pass Cisco exams
Pass4sure -Pass4sure.com The Worldwide Renowned Cisco Certification Material Provider .
Related Posts
