5 CCNA Certification Exam Dumps
1. Refer to the exhibit. How many broadcast domains exist in the exhibited topology?
A: one
B: two
C: three
D: four
E: five
F: six
Correct Answers: C
2. Refer to the exhibit. What two facts can be determined from the WLAN diagram? (Choose two.)
A:The area of overlap of the two cells represents a basic service set (BSS).
B:The network diagram represents an extended service set (ESS).
C:Access points in each cell must be configured to use channel 1.
D:The area of overlap must be less than 10% of the area to ensure connectivity.
E:The two APs should be configured to operate on different channels.
Correct Answers: B, E
3. Refer to the exhibit. The network administrator has created a new VLAN on Switch1 and added host C and host D. The administrator has properly configured switch interfaces FastEthernet0/13 through FastEthernet0/24 to be members of the new VLAN. However, after the network administrator completed the configuration, host A could communicate with host B, but host A could not communicate with host C or host D. Which commands are required to resolve this problem?
A: Router(config)# interface fastethernet 0/1.3
Router(config-if)# encapsulation dot1q 3
Router(config-if)# ip address 192.168.3.1 255.255.255.0
B: Router(config)# router rip
Router(config-router)# network 192.168.1.0
Router(config-router)# network 192.168.2.0
Router(config-router)# network 192.168.3.0
C: Switch1# vlan database
Switch1(vlan)# vtp v2-mode
Switch1(vlan)# vtp domain cisco
Switch1(vlan)# vtp server
D: Switch1(config)# interface fastethernet 0/1
Switch1(config-if)# switchport mode trunk
Switch1(config-if)# switchport trunk encapsulation isl
Correct Answers: A
4. Refer to the exhibit. The access list has been configured on the S0/0 interface of router RTB in the outbound direction. Which two packets, if routed to the interface, will be denied? (Choose two.)
access-list 101 deny tcp 192.168.15.32 0.0.0.15 any eq telnet
access-list 101 permit ip any any
A: source ip address: 192.168.15.5; destination port: 21
B: source ip address:, 192.168.15.37 destination port: 21
C: source ip address:, 192.168.15.41 destination port: 21
D: source ip address:, 192.168.15.36 destination port: 23
E: source ip address: 192.168.15.46; destination port: 23
F: source ip address:, 192.168.15.49 destination port: 23
Correct Answers: D, E
5. Refer to the exhibit. Switch1 has just been restarted and has passed the POST routine. Host A sends its initial frame to Host C. What is the first thing the switch will do as regards populating the switching table?
A: Switch1 will add 192.168.23.4 to the switching table.
B: Switch1 will add 192.168.23.12 to the switching table.
C: Switch1 will add 000A.8A47.E612 to the switching table.
D: Switch1 will add 000B.DB95.2EE9 to the switching table.
Correct Answers: C
TestKing - TestKing.com Help you pass Cisco exams
Pass4sure -Pass4sure.com The Worldwide Renowned Cisco Certification Material Provider .
Related Posts
